Mining Network Review: Blackminer F1mini+ Recommended for Home Mining

Compared with Blackminer F1mini, it inherits the advantages of low power consumption and low noise, with power consumption between 110~120w and noise below 50dB.

Blackminer F1min+ currently supports three algorithms, see the table below for details

parameter:

Weight: 271g (net weight) 490g (packaging)

Size: 17cmx16cmx11cm (packaging)

Noise: Nearly silent

Network connection: Ethernet

Operating environment: Working temperature: 0℃~40℃; Working humidity: 5%RH~95%RH, non-condensing.

Appearance real shot:

The interface side has a power port, power switch, network cable port, Reset button, IP button, status indicator light, alarm light, TF card slot, etc.

Installation and Debugging

      The hardware connection and installation of the mining machine is very simple, just plug in the power cord and the network cable.

1. Find the mining machine IP address
The mining machine uses DHCP to automatically assign an IP address by default. On the connection port side of the mining machine, press the IP button. After the red light flashes 3 times, release the IP button and you can see the mining machine IP in the management software.

2. Enter the mining machine backend
Open the computer browser, enter the mining machine IP obtained above in the browser address bar, press Enter to enter the login page, and enter "root" for both the username and password.

3. Configure the mining machine

Click "Configuration" - "Pool/Miner" option to see 3 algorithms, mining pool, wallet address configuration, save after configuration is completed

4. Mining machine operation status

In the "Miner Status" option, you can view the operating status of the mining machine

5. Test computing power and power consumption

Veriblock (VBK) has an average hashrate of 1.36GH/s and a power of 10.6W

Verus (VRSC) has an average hashrate of 37.1MH/s and a power of 30.9W

Odocrypt (DGB) has an average hashrate of 522MH/s and a power of 89.5W

6. In terms of temperature, the temperature of the mining machine tested at close range is 25 degrees.

7. In terms of noise, basically no noise can be heard, it is very quiet and can be placed anywhere.

Summarize

1. This single-chip Blackminer F1mini+ mining machine has the heat sink installed in advance. It has a compact design, is plug-and-play, and does not require any assembly procedures. It is very suitable for use as an entry-level FPGA mining machine.

2. The performance is stable and all parameters are consistent with the data published on the official website.

3. This mining machine is convenient and compact, with high performance, low power consumption and low noise, making it a must-have for beginners in home mining.

Blackminer F1mini+ official introduction: https://www.hashaltcoin.com/cn/batches/16

Contact Email: [email protected]

Mobile & WeChat: +86 18612535678