Bitcoin mining machine Antminer batch management software

Antminer management software v0.15 released:
1. Add information push and optimize the official push information startup process of Antminer
2. Change the icon to the ant icon
3. Added the function of sorting the results of mining machine detection by clicking the table header
4. Added the function of timing detection of mining machines
5. Support the full range of Antminers (Antminer S3, S3+, S3++, S4, S4+, S5, S5+ (not yet released), S6 (not yet released))

1. Batch scanning mode: Batch detection of Bitcoin mining machine computing power and miners

Open the Bitcoin mining machine management software, click Pool info, enter your IP segment, then click OK, and then click Check Pools, and the scanning mode will start.

You can click Export to export the scan results to Excel. Through Excel, you can sort and find out the low-computing-power mining machines and non-working mining machines for easy maintenance.

2. Batch setting mode: Batch setting of mining pools and miners

Open the software, click Pool info, enter your IP segment, then click OK, fill in pool 1, pool 2 and other information, click start, and you can batch set the miner pool information.

Special attention:

1. Worker Here, if your miner name is liyingfei, just fill in liyingfei. (Note the dot behind, it must be filled in. If the format of the mining pool is underlined, then fill in liyingfei_), then click the IP behind

The miner set up in this way will be different for each mining machine. For example, if the mining machine IP is 192.168.1.99, then the miner name is liyingfei.1×99. If you click none at the end, the miner of each machine will be the same.

2. Do not fill in the prefix of mining pool stratum+tcp:// http://! Just write solo.antpool.com:3333 or stratum.f2pool.com:3333. Writing the prefix will cause the change to fail.

Welcome to use our Bitmain official mining pool: www.antpool.com

3. Batch restart, set voltage, scan frequency, set frequency

Open the software, click Freq&Voltage, enter your IP segment, and click OK

Set Volt: Set voltage; Reboot: Reboot; Scan Freq: Scan frequency; Set Freq: Set frequency

Download address: BitMainTool (V0.1 version, please follow this article to get software upgrades)